User`s manual
Table Of Contents
- Mediant 2000 & TP-1610 & TP-260/UNI SIP User’s Manual Version 5.0
- Table of Contents
- List of Figures
- List of Tables
- Notices
- 1. Overview
- 2. Physical Description
- 3. Installation
- 4. Getting Started
- 5. Web Management
- Computer Requirements
- Protection and Security Mechanisms
- Accessing the Embedded Web Server
- Getting Acquainted with the Web Interface
- Protocol Management
- Advanced Configuration
- Status & Diagnostic
- Software Update Menu
- Maintenance
- Logging Off the Embedded Web Server
- 6. Gateway's ini File Configuration
- Secured ini File
- Modifying an ini File
- The ini File Content
- The ini File Structure
- The ini File Example
- Networking Parameters
- System Parameters
- Web and Telnet Parameters
- Security Parameters
- RADIUS Parameters
- SNMP Parameters
- SIP Configuration Parameters
- Voice Mail Parameters
- ISDN and CAS Interworking-Related Parameters
- Number Manipulation and Routing Parameters
- E1/T1 Configuration Parameters
- Channel Parameters
- Configuration Files Parameters
- 7. Using BootP / DHCP
- 8. Telephony Capabilities
- Working with Supplementary Services
- Configuring the DTMF Transport Types
- Fax & Modem Transport Modes
- Event Notification using X-Detect Header
- ThroughPacket™
- Dynamic Jitter Buffer Operation
- Configuring the Gateway’s Alternative Routing (based on Conn
- Call Detail Report
- Supported RADIUS Attributes
- Trunk to Trunk Routing Example
- Proxy or Registrar Registration Example
- SIP Call Flow Example
- SIP Authentication Example
- 9. Networking Capabilities
- 10. Advanced PSTN Configuration
- 11. Advanced System Capabilities
- 12. Special Applications
- 13. Security
- 14. Diagnostics
- 15. SNMP-Based Management
- SNMP Standards and Objects
- Carrier Grade Alarm System
- Cold Start Trap
- Third-Party Performance Monitoring Measurements
- TrunkPack-VoP Series Supported MIBs
- Traps
- SNMP Interface Details
- SNMP Manager Backward Compatibility
- Dual Module Interface
- SNMP NAT Traversal
- SNMP Administrative State Control
- AudioCodes’ Element Management System
- 16. Configuration Files
- Appendix A. Selected Technical Specifications
- Appendix B. Supplied SIP Software Kit
- Appendix C. SIP Compliance Tables
- Appendix D. The BootP/TFTP Configuration Utility
- Appendix E. RTP/RTCP Payload Types and Port Allocation
- Appendix F. RTP Control Protocol Extended Reports (RTCP-XR)
- Appendix G. Accessory Programs and Tools
- Appendix H. Release Reason Mapping
- Appendix I. SNMP Traps
- Appendix J. Installation and Configuration of Apache HTTP Server
- Appendix K. Regulatory Information
SIP User's Manual 2. Physical Description
Version 5.0 31 October 2006
2.2.2 Rear Transition Module
The RTM includes PSTN trunks, an Ethernet interface, and an optional RS-232 connector
(available only on the 1, 2 and 4-span configuration).
The Ethernet interface features dual 10/100 Base-TX, RJ-45 shielded connectors for (an
active / standby) redundancy scheme providing protection against the event of a failure.
The PSTN interface is available in 1-span, 2-span, 4-span, 8-span, or 16-span rear panels.
Rear panel with two 50-pin female Telco connectors (DDK 57AE-40500-21D) (shown in
Figure
2-3) is required for a gateway equipped with 16 E1/T1 spans. Rear panel with RJ-
48c connectors (shown in Figure
2-4) is required for a gateway equipped with 1, 2, 4, or 8
E1/T1 spans. The physical difference between the 1-Span, 2-Span and 4-Span RTMs, and
the 8-span RTM is that the RJ-48c ports are depopulated correspondingly.
Figure 2-3: Rear Panel with two 50-pin Connectors for 16 Trunks
Table 2-8: Rear Panel with two 50-pin Connectors for 16 Trunks Component Descriptions
Item # Label Component Description
1
ETHERNET
2 Ethernet Ports. 2 RJ-45 network connectors.
2
TRUNKS
E1/T1 trunks 9 to 16. 50-pin female Telco connector.
3
TRUNKS
E1/T1 trunks 1 to 8. 50-pin female Telco connector.
Figure 2-4: Rear Panel with 8 RJ-48c Connectors for 8 Trunks
Table 2-9: Rear Panel with 8 RJ-48c Connectors for 8 Trunks Component Descriptions
Item # Label Component Description
1
ETHERNET
2 Ethernet Ports. 2 RJ-45 network connectors
2
TRUNKS
8 E1/T-1 Spans. 8 RJ-48c trunk connectors
21