User`s manual

Mediant 2000 & TP-1610 & TP-260
SIP User's Manual 138 Document #: LTRT-68805
6.7 System Parameters
Table 6-2: System Parameters (continues on pages 138 to 143)
ini File Field Name
Web Parameter Name
Valid Range and Description
EnableDiagnostics
Checks the correct functionality of the different hardware components on the
gateway. On completion of the check, if the test fails, the gateway sends
information on the test results of each hardware component to the Syslog
server.
0 = Rapid and Enhanced self-test mode (default).
1 = Detailed self-test mode (full test of DSPs, PCM, Switch, LAN, PHY and
Flash).
2 = A quicker version of the Detailed self-test mode (full test of DSPs, PCM,
Switch, LAN, PHY, but partial test of Flash).
For detailed information, refer to Section
14.1 on page 303.
GWAppDelayTime
[Delay After Reset [sec]]
Defines the amount of time (in seconds) the gateway’s operation is delayed
after a reset cycle.
The valid range is 0 to 45. The default value is 7 seconds.
Note: This feature helps to overcome connection problems caused by some
LAN routers or IP configuration parameters change by a DHCP Server.
ActivityListToLog
[Activity Types to Report via
'Activity Log' Messages]
The Activity Log mechanism enables the gateway to send log messages (to a
Syslog server) that report certain types of web actions according to a pre-
defined filter.
The following filters are available:
PVC (Parameters Value Change) - Changes made on-the-fly to parameters.
AFL (Auxiliary Files Loading) - Loading of auxiliary files (e.g., via Certificate
screen).
DR (Device Reset) - Device reset via the Maintenance screen.
FB (Flash Memory Burning) - Burning of files / parameters to flash (e.g.,
Maintenance screen).
SWU (Device Software Update) - cmp loading via the Software Upgrade
Wizard.
ARD (Access to Restricted Domains) - Access to Restricted Domains.
The following screens are restricted:
(1) ini parameters (AdminPage)
(2) General Security Settings
(3) Configuration File
(4) IPSec/IKE tables
(5) Software Upgrade Key
(6) Internal Firewall
(7) Web Access List.
(8) Web User Accounts
NAA (Non Authorized Access) - Attempt to access the Embedded Web Server
with a false / empty username or password.
SPC (Sensitive Parameters Value Change) - Changes made to sensitive
parameters:
(1) IP Address
(2) Subnet Mask
(3) Default Gateway IP Address
(4) ActivityListToLog
For example:
ActivityListToLog = 'pvc', 'afl', 'dr', 'fb', 'swu', 'ard', 'naa', 'spc'