User`s manual

Mediant 2000 & TP-1610 & TP-260
SIP User's Manual 120 Document #: LTRT-68805
¾ To load an auxiliary file to the gateway, take these 8 steps:
1. Open the ‘Auxiliary Files’ screen (Software Upgrade menu > Load Auxiliary Files);
the ‘Auxiliary Files’ screen is displayed.
Figure 5-51: Auxiliary Files Screen
2. Click the Browse button that is in the field for the type of file you want to load.
3. Navigate to the folder that contains the file you want to load.
4. Click the file and click the Open button; the name and path of the file appear in the
field beside the Browse button.
5. Click the Send File button that is next to the field that contains the name of the file you
want to load. An exclamation mark in the screen section indicates that the file’s
loading doesn’t take effect on-the-fly (e.g., CPT file).
6. Repeat steps 2 to 5 for each file you want to load.
Notes:
• Saving an auxiliary file to flash memory may disrupt traffic on the
gateway. To avoid this, disable all traffic on the device before saving to
flash by performing a graceful lock (refer to Section 5.9.1 on page 122).
• A device reset is required to activate a loaded CPT file, and may be
required for the activation of certain ini file parameters.
7. To save the loaded auxiliary files so they are available after a power fail, refer to
Section 5.9.2 on page 124.
8. To reset the gateway, refer to Section 5.9.3 on page 125.