User`s manual

Table Of Contents
Mediant 2000 & TP-1610 & TP-260
SIP User's Manual 106 Document #: LTRT-68805
5.7 Status & Diagnostic
Use this menu to view and monitor the gateway’s channels, Syslog messages, hardware /
software product information, and to assess the gateway’s statistics and IP connectivity
information.
5.7.1 Gateway Statistics
Use the screens under Gateway Statistics to monitor real-time activity such as IP
Connectivity information, call details and call statistics, including the number of call
attempts, failed calls, fax calls, etc.
Note: The Gateway Statistics screens doesn’t refresh automatically. To view updated
information, re-access the screen you require.
5.7.1.1 IP Connectivity
The IP Connectivity screen provides you with an online read-only network diagnostic
connectivity information on all destination IP addresses configured in the Tel to IP Routing
table.
Notes:
This information is available only if the parameter
‘AltRoutingTel2IPEnable’ (described in Table 6-10) is set to 1 (Enable) or
2 (Status Only).
The information in columns ‘Quality Status’ and ‘Quality Info.’ (per IP
address) is reset if two minutes elapse without a call to that destination.
¾ To view the IP connectivity information, take these 2 steps:
1. Set ‘AltRoutingTel2IPEnable’ to 1 or 2.
2. Open the ‘IP Connectivity’ screen (Status & Diagnostics menu > Gateway Statistics
submenu > IP Connectivity); the ‘IP Connectivity’ screen is displayed (Figure 5-35).
Figure 5-35: IP Connectivity Screen