User`s manual

Mediant 2000 & TP-1610 & TP-260
SIP User's Manual 104 Document #: LTRT-68805
5.6.9.2 Configuring the SNMP Community Strings
Use the SNMP Community Strings table to configure up to five read-only and up to five
read / write SNMP community strings, and to configure the community string that is used
for sending traps. For detailed information on SNMP community strings, refer to section
15.7.1 on page 316.
¾ To configure the SNMP Community Strings, take these 5 steps:
1. Access the ‘Management Settings’ screen (Advanced Configuration menu >
Management Settings); the ‘Management Settings’ screen is displayed.
2. Open the SNMP Community Strings screen by clicking the arrow sign (-->) to the right
of the SNMP Community Strings label; the SNMP Community Strings screen is
displayed (Figure 5-33).
3. Configure the SNMP Community Strings parameters according to Table 6-6 on page
148.
4. Click the Submit button to save your changes.
5. To save the changes so they are available after a power fail, refer to Section 5.9.2 on
page 124.
Figure 5-33: SNMP Community Strings Screen
Note: To delete a community string, check the Delete checkbox to the left of the
community string you want to delete and click the button Submit.