Specifications

Spectralink 84-Series with AudioCodes Gateway and Avaya Communication Manager: Interoperability Guide
1725-86914-000_C.docx
September 2013 92
8. Add the Route Pattern
Note: What are the existing route patterns?
If some route patterns already exist in the system you would use the command
change route pattern x.
1 Enter the command add route-pattern x, where x is the number of the unique route
pattern you created in step 7 (In the test case 2 was used).
2 Set these parameters:
Name
Enter a meaningful name. The test used AC_Mediant Gateway
Group Number
Enter the Trunk Group Number you created in Step 4 (Mine is TG #2)
FRL
Choose a facility restriction level that will not compromise your sites'
security practices
Numbering Format
pub-unk
3 Press Esc-E to submit.
Note: Test the configuration
If you are not adding multiple T1’s / PRI’s, then your configuration should be complete
at this point and you should skip forward to the testing section to verify functionality.