Specifications

Spectralink 84-Series with AudioCodes Gateway and Avaya Communication Manager: Interoperability Guide

1725-86914-000_C.docx

September 2013 82

3. Add Signaling Group to Trunk Group

Create a signaling group for the trunks and put it into the Mediant Gateway trunk group. We

used signaling group #2 for this test. You can choose any available signaling group number.

1 Use the command add signaling-group x, where x is the number of the signaling group

you wish to add.

Note: What are the existing signaling groups?

You can view the existing signaling-groups by executing a list signaling-group

command.

2 (Conditional) If you have a Group Type field, set it to isdn-pri. This field was not

available in the 5.2 system but may be available on other system versions.

3 Configure the following

Associated Signaling

Primary D Channel

Enter xxxxx24, where xxxxx is the location of the

DS1 media module configured above.

TSC Supplementary Service Protocol

4 Press Esc-E to submit.