Specifications

1725-86914-000_C.docx
September 2013 76
Chapter 9: Configuration Requirements
of the Avaya Communication Manager
This configuration assumes that the Avaya Communication Manager is already installed in the
facility and has at least one available PRI card.
Admin Tip: Avaya Communication Manager software version supported.
The configuration referenced below was obtained from an Avaya Communications
Manager running version 5.2. Supported versions range from 5.0 to 6.1. The screens
and parameters referenced should be similar on these versions as well.
1. Q.SIG
Q.SIG parameters are required.
To set or confirm Q.SIG parameters:
1 Login to the Avaya ACM and perform the display system-parameters customer-options
command.
2 Go to page 3.
3 Ensure that these four fields are all set to a value of Yes. If not you will need to log back
into the system using a login with sufficient permissions to change these, and modify
them by performing a "change system-parameters customer-options". If you do not have
access to change these and need to, you will need to contact a reseller.
ARS/AAR Dialing without
FAC
Y
DCS (Basic)
Y
DCS Call Coverage
Y
DCS with Rerouting
Y
DS1 MSP
Y