Specifications

1725-86914-000_C.docx
September 2013 75
Chapter 8: Test Basic Functionality
Once the Mediant Gateway configuration is complete, conduct a test of basic handset
functionality following the following table. These tests exercise the handsets connectivity with
the Mediant Gateway without using the PBX link.
Registration
After powering on the phone, check the Mediant Gateway ’s AoR
screen and check the handset’s line registration status.
Outgoing Call
Dial another 84-Series handset or SIP endpoint registered with the
Mediant Gateway . Verify that a call path is established. The test does
not require the PRI link.
Incoming Call
Have another registered SIP endpoint call a registered 84-Series
handset, ensure the handset rings and a call path is established. The
test does not require the PRI link.
SIP URL Call
Call an 84-Series handset directly uses the IP address. This bypasses
the Mediant Gateway . If this call fails there may be basic network
issues.
Up to 6 call appearances per
line
Each line registration supports by default 24 calls per line. This may be
changed using the configuration parameter.
Call Hold & Resume
When in call use the hold feature to hold the active call. Retrieve the
call using the resume button.
Speaker & Mute
When in call try the handset mute and speakerphone capability.
Do Not Disturb (DND)
Using the handset set the DND capability, and try calling the handset, it
should not ring, and the calling party should receive an busy tone.
Transfer (Attended/
Unattended)
If three wireless handsets are available, set up a call between two
handsets, then using the phone softkey redirect the call to the third
handset using blind or attended transfer. Verify the call is handed off to
the third handset.