Specifications

Spectralink 84-Series with AudioCodes Gateway and Avaya Communication Manager: Interoperability Guide
1725-86914-000_C.docx
September 2013 52
Module
Use the dropdown list to select the correct module.
From Trunk
1
To Trunk
1
Channels
1-23 (1-30 for E1)
Phone Number
Enter 100000 (see note below)
Trunk Group ID
1
Tip: Setting a sensible Phone Number
The Phone Number is the starting point of a range of numbers that the Mediant
Gateway uses internally. When choosing a phone number choose a range of
numbers that is outside the range of extensions used in your facility. The range will
be from the configured phone number to the phone number plus the number of DS0
voice channels, i.e. for a single T1, 23 channels, the Mediant Gateway would use
extensions 100000 through 100022. We are using 100000 here as it is unlikely that
any facility will have extensions of this length. DO NOT USE EXTENSIONS THAT
ARE USED ELSEWHERE IN THE SYSTEM.
5 Press the Submit button.
To set “unknown” text to display if the Caller ID is not provided.
1 Select the Configuration tab and navigate to VOIP > GW and IP to IP > Manipulations >
Source Number Tel -> IP.
2 Add a source Trunk Group by entering 1 in the field and clicking the Add button. Set or
verify the following parameters:
Source IP Group
-1
Destination Prefix
*
Source Prefix
1000xx#
This number is derived from the Phone Number entered in the
Group Index for the Trunk Group configured previously.
Stripped Digits from Left
6
Stripped Digits from Right
0
Prefix to Add
unknown
Suffix to Add
[leave blank]