Specifications

1725-86914-000_C.docx
September 2013 33
Chapter 6: Initial Configuration of the
Mediant Gateway
This chapter describes the procedure for initial configuration of a Mediant Gateway (Mediant
Gateway ) running software version 6.20.
The default Mediant Gateway username and password is Admin and Admin respectively, this
is required when web-browsing to the Mediant Gateway . Instructions for changing it are in the
last section of this chapter.
Caution: Backup your configuration
Save and backup your configuration when you complete the configuration steps
below.
1. Connect Mediant Gateway to a single computer
Warning: Do not connect the Mediant Gateway to the network
Do not connect the Mediant Gateway to your corporate network before configuring it
per the instructions in this chapter.
1 Establish a connection between the Mediant Gateway and a single computer or laptop.
By default the Mediant Gateway has the following settings:
IP Address
192.168.0.1
Sub net
255.255.255.0
2 Change the Network Config of the pc to match the Mediant Gateway ’s default network
settings i.e. 192.168.0.100, 255.255.255.0.
3 Open a browser and enter the IP address of the Mediant Gateway http://192.168.0.1.
4 When prompted, enter the default username Admin and password Admin. Note the
capital A.