Specifications

Spectralink 84-Series with AudioCodes Gateway and Avaya Communication Manager: Interoperability Guide
1725-86914-000_C.docx
September 2013 120
2 Log on to the Web interface.
3 Open the Configuration File by doing one of the following:
a On the toolbar, click Device Actions, and then choose Load Configuration File. Or,
b Open the Maintenance tab and navigate to Software Update > Configuration File.
4 Click the Browse button corresponding to the Send INI File button, navigate to the empty
ini file, select the file, and then click Open.
5 Click the Send INI File button, and then at the prompt, click OK; the device uploads the
ini file and then resets the device to default settings (based on the cmp file currently
running on the device).
6 After a few minutes you should be able to browse back into the device using the same IP
address the device had prior to restoring defaults.
Using the serial adapter cable
(see AudioCodes document LTRT-30300 Restoring Factory Defaults Technical Note)
A serial adapter cable ships with the Mediant Gateway and it is used when you cannot access
the Mediant Gateway through the network. It has a proprietary com port connector which is not
commercially available through other sources. Please keep this cable close to the Mediant
Gateway in case troubleshooting is needed.