User`s manual

AudioCodes Mediant 800 MSBG Installation and Configuration Guide Page 9 of 47
Initial Setup – VoIP Settings:
In this section we’ll be configuring the Mediant 800 to accept & route calls.
The Mediant 800 uses an organizational structure where groups of settings are
contained in a Signaling Media Realm (SRD). For further description please see
the Configuring SRD Table section of the Mediant 800 MSBG User’s Manual.
There are several pieces that will need to be configured to construct the
SRD. They are:
1) Media Realm
2) IP Group
3) IP Profile
4) Proxy Set
We will also be configuring the VoIP Interface settings (ports, etc), and
Routing. The Routing Table is where SRDs & IP Groups are used to ease the
configuration of routing between networks.
After the Mediant 800 has been connected to your LAN and you have
established connectivity, continue below. The MSBG has built in diagnostic tools
(PING, ARP, & Traceroute) you can use to verify successful configuration. They
are located under Status & Diagnostics > Data Status > Diagnostics.
1. Select VoIP > Media > Media Realm Configuration