User`s manual

AudioCodes Mediant 800 MSBG Installation and Configuration Guide Page 34 of 47
28. Click Submit
29. Select Device Actions > Reset
30. Ensure Burn to Flash is set to Yes and then click Reset
31. Log back in after reboot
32. Select VoIP > Control Network > Proxy Sets Table
33. Ensure that the proper proxy set has the Transport Type set to TLS
for each entry in its Proxy Address table. Also put the SIPS
communication port on the end of each IP Address.
34. If one of your proxy sets does not communicate using TLS ensure that
that Proxy Set has the SIP communication port on the end of each of
its IP Addresses.
35. Select VoIP > Coders & Profiles > IP Profile Settings