User`s manual

AudioCodes Mediant 800 MSBG Installation and Configuration Guide Page 10 of 47
3. The default configuration has no media realms configured. You will
need at least two realms configured. One for WAN and one for Voice.
Enter a number next to Add Index and click Add. For the purposes of
this document, we will be considering Voice indexes to be between 1 &
10 and WAN indexes to be between 11 & 20.
4. Enter the following settings:
a. Media Realm Name: Voice
b. IPv4 Interface Name: Voice
c. Port Range Start: This is as needed.
i. If you configure Port Range Start, then Port Range End
will be automatically calculated. Also, you will need to
configure Port Range Start for all other media realms.
These port ranges cannot overlap.
d. Number of Media Session Legs: This will limit the number of
active calls the Media Realm will allow. -1 = Unlimited
5. Click Apply. A dialog box appears telling you that you’ve configured
and offline parameter. Ignore this for now as we will be rebooting later.
6. Add the WAN Media realm following the same steps.
7. Click Apply. A dialog box may appear telling you that you’ve
configured and offline parameter. Ignore this for now as we will be
rebooting later.