User`s manual

AudioCodes Mediant 800 MSBG Page 52 of 66
Installation and Configuration Guide
Advanced Configuration - TLS
31. Click Submit
32. Change your Proxy Set to use TLS
33. Select Device Actions > Reset
34. Ensure Burn to Flash is set to Yes and then click Reset
35. Log back in after reboot
36. Navigate to VoIP > Control Network > Proxy Sets Table
37. Ensure that the proper proxy set has the Transport Type
set to TLS for each entry in its Proxy Address table. Also
put the SIPS communication port on the end of each IP
Address.
38. If one of your proxy sets does not communicate using TLS
ensure that that Proxy Set has the SIP communication
port on the end of each of its IP Addresses.