User`s manual

AudioCodes Mediant 800 MSBG Page 38 of 66
Installation and Configuration Guide
Initial Setup - FXO/FXS Configuration
11. Select the Module you wish to configure eg Module 1 FXS
12. Configure the Channels you wish to use eg 1-4
*See diagram step 11.
13. For an FXS enter the First Station Extension to be used by the FXS
devices (eg 2101) in the Phone Number field. For an FXO enter
the external Phone Number in the Phone Number field.
*See diagram step 11.
Note: The Device will automatically increment each Station
Extension. If channels 1-3 are selected and 2101 is enter for the
Phone Number, then Port 1 will be 2101, Port 2 will be 2102, etc. If
the Station Extensions to be assigned are not sequential, a
separate record for each port will need to be configured. This also
applies to the FXO.
14. Enter the appropriate Trunk Group ID to meet your configuration
needs.
Note: Multiple entries in the table can have the same Trunk Group
ID.