User`s manual
AudioCodes Mediant 800 MSBG Page 34 of 66
Installation and Configuration Guide
Initial Setup - FXO/FXS Configuration
FXO/FXS Configuration
In this section we will configure the Mediant 800 to accept & route
calls using the FXO/FXS ports. Refer to FXO/FXS section of
Mediant 800 MSBG SIP User’s Manual.
1. Navigate to
GW and IP to IP > Analog Gateway > FXO
Settings
2. Set
Dialing Mode
to
One Stage
.
NOTE: Two-Stage dialing will present a dial tone when the line is