User`s manual

AudioCodes Mediant 800 MSBG Page 17 of 66
Installation and Configuration Guide
Initial Setup - VoIP Settings
19. Navigate to VoIP > Coders and Profiles > IP Profile
Settings
20. Here you can configure various settings to handle
variations of the SIP General Parameters. You then
assign these Profiles to their respective IP Groups.
These profiles can be used to handle:
a. Differences in DSCP from one network to another
b. If one network uses SRTP and another uses RTP if
Media Security is Enabled
c. If one network uses T.38 Relay and another does not
allow faxing
d. If you set up Coder Groups you can assign them to the
IP Profile and then assign the IP Profile to the proper IP
Groups.
e. Etc.
21. Once your configurations are complete, press Submit
and, if necessary, assign them to the proper IP Groups.