User`s manual

AudioCodes Mediant 800 MSBG Page 10 of 66
Installation and Configuration Guide
Initial Setup - VoIP Settings
VoIP Settings
In this section we’ll begin configuring the Mediant 800 to
accept & route calls. The Mediant 800 uses an organizational
structure where groups of settings are contained in a Signaling
Routing Domain (SRD). For further description please see the
Configuring SRD Table section of the Mediant 800 MSBG User’s
Manual.
There are several pieces that will need to be configured to
construct the SRD. They are:
1) SIP Interface
2) Media Realm
3) IP Group
4) IP Profile
5) Proxy Set
After the Mediant 800 has been connected to your LAN and
you have established connectivity, continue below. The MSBG has
built in diagnostic tools (PING, ARP, & Traceroute) you can use to
verify successful configuration. They are located under Status &
Diagnostics > Data Status > Diagnostics.
General VoIP Settings
These settings are for any of the M800 models and will be needed
for SBC, TDM, or FXO/FXS functionality.
1. Navigate to VoIP > Media > Media Realm Configuration