User`s manual

Version 5.4 99 May 2008
SIP User's Manual 3. Web-Based Management
ini File Field Name
Web Parameter Name
Valid Range and Description
 [19] E1 KOR ISDN = Korean operator
 [20] T1 HKT ISDN = Hong Kong - HKT over T1
 [21] E1 QSIG
 [23] T1 QSIG
 [31] E1 FRENCH VN3 ISDN
 [35] T1 DMS100 Meridian ISDN
 [40] E1 NI2 ISDN
 [41] E1 CAS R15
 [50] BRI EURO ISDN
 [51] BRI NI2 ISDN
 [52] BRI DMS100 ISDN
 [53] BRI 5ESS 10 ISDN
 [54] BRI QSIG
 [56] BRI NTT = BRI ISDN Japan (Nippon Telegraph)
Note: The device simultaneously supports different variants of CAS and
PRI protocols on different E1/T1 spans (no more than four simultaneous
PRI variants).
Clock Master
[ClockMaster]
Determines the Tx clock source of the E1/T1 line.
 [0] Recovered = Generate the clock according to the Rx of the E1/T1
line (default).
 [1] Generated = Generate the clock according to the internal TDM
bus.
Notes:
 The source of the internal TDM bus clock is determined by the
parameter TDMBusClockSource.
 For detailed information on configuring the device's clock settings,
refer to ''Clock Settings'' on page 459.
Auto Clock Trunk Priority
[AutoClockTrunkPriority]
Defines the trunk priority for auto-clock fallback (per trunk parameter).
 0 to 99 = priority (0 is the highest = default).
 100 = the SW never performs a fallback to that trunk (usually used to
mark untrusted source of clock).
Note: Fallback is enabled when the TDMBusPSTNAutoClockEnable
parameter is set to 1.
Line Code
[LineCode]
Use to select B8ZS or AMI for T1 spans, and HDB3 or AMI for E1 spans.
 [0] B8ZS = use B8ZS line code (for T1 trunks only) default.
 [1] AMI = use AMI line code.
 [2] HDB3 = use HDB3 line code (for E1 trunks only).
Note: This parameter is not configurable for BRI interfaces; the device
automatically uses the Modified Alternate Mark Invert (MAMI) line code.