User`s manual

Version 5.4 85 May 2008
SIP User's Manual 3. Web-Based Management
Parameter Description
Caller ID Transport Type
[CallerIDTransportTyp
e]
Determines the device's behavior for Caller ID detection.
 [0] Disable = Caller ID is not detected - DTMF digits remain in the voice
stream.
 [1] Relay = Caller ID is detected - DTMF digits are erased from the voice
stream.
 [3] Mute = Caller ID is detected - DTMF digits are erased from the voice
stream (default).
Caller ID Type
[CallerIDType]
Defines one of the following standards for detection (FXO) and generation
(FXS) of Caller ID, and detection (FXO) and generation (FXS) of MWI (when
specified) signals:
 [0] Bellcore = Caller ID and MWI (default)
 [1] ETSI = Caller ID and MWI
 [2] NTT
 [4] Britain
 [16] DTMF ETSI
 [17] Denmark = Caller ID and MWI
 [18] India
 [19] Brazil
Notes:
 This parameter is applicable only to Mediant 1000.
 Typically, the Caller ID signals are generated/detected between the first
and second rings. However, sometimes the Caller ID is detected before
the first ring signal. In such a scenario, configure RingsBeforeCallerID to
0.
 Caller ID detection for Britain [4] is not supported on the device’s FXO
ports. Only FXS ports can generate the Caller ID for Britain [4].
 To select the Bellcore Caller ID sub standard, use the parameter
BellcoreCallerIDTypeOneSubStandard. To select the ETSI Caller ID sub-
standard, use the parameter ETSICallerIDTypeOneSubStandard.
 To select the Bellcore MWI sub standard, use the parameter
BellcoreVMWITypeOneStandard. To select the ETSI MWI sub standard,
use the parameter ETSIVMWITypeOneStandard.
 If you define Caller ID Type as NTT [2], you need to define the NTT DID
signaling form (FSK or DTMF) using NTTDIDSignallingForm.
V.21 Modem Transport
Type
[V21ModemTransportT
ype]
V.21 Modem Transport Type used by the device.
 [0] Disable = Disable (Transparent) -- default
 [1] Enable Relay = N/A
 [2] Enable Bypass.
 [3] Events Only = Transparent with Events.
V.22 Modem Transport
Type
[V22ModemTransportT
ype]
V.22 Modem Transport Type used by the device.
 [0] Disable = Disable (Transparent)
 [1] Enable Relay = N/A
 [2] Enable Bypass = (default)
 [3] Events Only = Transparent with Events