User`s manual

SIP User's Manual 84 Document #: LTRT-83303
Mediant 1000 & Mediant 600
3.4.2.2 Configuring the Fax / Modem / CID Settings
The 'Fax/Modem/CID Settings' page is used for configuring fax, modem, and Caller ID
(CID) parameters.
¾ To configure the fax, modem, and CID parameters, take these 4
steps:
1. Open the 'Fax/Modem/CID Settings' page (Configuration tab > Media Settings menu
> Fax/Modem/CID Settings page item).
Figure 3-49: Fax/Modem/CID Settings Page
2. Configure the fax, Modem, and CID parameters according to the table below.
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, refer to ''Saving Configuration'' on page 265.
Table 3-16: Media Settings -- Fax/Modem/CID Parameters
Parameter Description
Fax Transport Mode
[FaxTransportMode]
Fax transport mode used by the device.
 [0] Disable = transparent mode.
 [1] T.38 Relay = (default).
 [2] Bypass.
 [3] Events Only.
Note: If parameter IsFaxUsed = 1, then FaxTransportMode is always set to
1 (T.38 relay).