User`s manual

SIP User's Manual 76 Document #: LTRT-83303
Mediant 1000 & Mediant 600
¾ To configure static IP routing, take these 3 steps:
1. Open the 'IP Routing Table' page (Configuration tab > Network Settings menu > IP
Routing Table page item).
Figure 3-46: IP Routing Table Page
2. In the 'Add a new table entry' group, add a new static routing rule according to the
parameters described in the table below.
3. Click Add New Entry; the new routing rule is added to the IP routing table.
To delete a routing rule from the table, select the 'Delete Row' check box that corresponds
to the routing rule entry, and then click Delete Selected Entries.
Table 3-13: IP Routing Table Description
Column Name
[ini File Parameter Name]
Description
Destination IP Address
[RoutingTableDestinationsCol
umn]
Specifies the IP address of the destination host / network.
Destination Mask
[RoutingTableDestinationMask
sColumn]
Specifies the subnet mask of the destination host / network.
The address of the host / network you want to reach is determined by an AND operation that is
applied to the fields 'Destination IP Address' and 'Destination Mask'. For example, to reach the
network 10.8.x.x, enter 10.8.0.0 in the field 'Destination IP Address' and 255.255.0.0 in the field
'Destination Mask'. As a result of the AND operation, the value of the last two octets in the field
'Destination IP Address' is ignored.
To reach a specific host, enter its IP address in the field 'Destination IP Address' and
255.255.255.255 in the field 'Destination Mask'.