User`s manual

SIP User's Manual 72 Document #: LTRT-83303
Mediant 1000 & Mediant 600
Table 3-11: Application Settings Parameters
Parameter Description
NTP Settings (For detailed information on Network Time Protocol (NTP), refer to ''Simple Network
Time Protocol Support'' on page 449.)
NTP Server IP Address
[NTPServerIP]
IP address (in dotted-decimal notation) of the NTP server.
The default IP address is 0.0.0.0 (i.e., internal NTP client is disabled).
NTP UTC Offset
[NTPServerUTCOffset]
Defines the Universal Time Coordinate (UTC) offset (in seconds) from
the NTP server.
The default offset is 0. The offset range is -43200 to 43200.
NTP Update Interval
[NTPUpdateInterval]
Defines the time interval (in seconds) that the NTP client requests for
a time update.
The default interval is 86400 (i.e., 24 hours). The range is 0 to
214783647.
Note: AudioCodes does not recommend setting this parameter to
beyond one month (i.e., 2592000 seconds).
Telnet Settings
Embedded Telnet Server
[TelnetServerEnable]
Enables or disables the device's embedded Telnet server. Telnet is
disabled by default for security reasons.
 [0] Disable (default)
 [1] Enable Unsecured
 [2] Enable Secured (SSL)
Telnet Server TCP Port
[TelnetServerPort]
Defines the port number for the embedded Telnet server.
The valid range is all valid port numbers. The default port is 23.
Telnet Server Idle Timeout
[TelnetServerIdleDisconnect
]
Defines the timeout (in minutes) for disconnection of an idle Telnet
session. When set to zero, idle sessions are not disconnected.
The valid range is any value. The default value is 0.
SSH Server Enable
[SSHServerEnable]
Enables or disables the embedded Secure Shell (SSH) server.
 [0] Disable (default)
 [1] Enable
SSH Server Port
[SSHServerPort]
Defines the port number for the embedded SSH server.
Range is any valid port number. The default port is 23.
DNS Settings
DNS Primary Server IP
[DNSPriServerIP]
IP address of the primary DNS server. Enter the IP address in dotted-
decimal notation, for example, 10.8.2.255.
Note: To use Fully Qualified Domain Names (FQDN) in the 'Tel to IP
Routing' table, you must define this parameter.
DNS Secondary Server IP
[DNSSecServerIP]
IP address of the second DNS server. Enter the IP address in dotted-
decimal notation, for example, 10.8.2.255.
STUN Settings
Enable STUN
[EnableSTUN]
Determines whether Simple Traversal of UDP through NATs (STUN)
is enabled.
 [0] Disable (default)
 [1] Enable
When enabled, the device functions as a STUN client and
communicates with a STUN server located in the public Internet.