User`s manual
SIP User's Manual 66 Document #: LTRT-83303
Mediant 1000 & Mediant 600
Table 3-9: Network Settings -- IP Settings Parameters
Parameter Description
IP Settings
IP Networking Mode
[EnableMultipleIPs]
Determines the IP network scheme.
[0] Single IP Network = Single IP network (default).
[1] Multiple IP Networks = Multiple IP networks (OAMP, Media, and
Control).
[1] Dual IP (Media & Control) = Multiple IP networks.
[1] Dual IP (OAM & Control) = Multiple IP networks.
[1] Dual IP (OAM & Medial) = Multiple IP networks.
Note: This parameter is not relevant when using Multiple Interface
tables, activated by clicking the Multiple Interface Table
button
described below (refer to ''Configuring the Multiple Interface Table'' on
page 68").For detailed information on Multiple IPs, refer to ''Multiple IPs''
on page 450.
Single IP Settings
IP Address
IP address of the device. Enter the IP address in dotted-decimal
notation, for example, 10.8.201.1.
Notes:
A warning message is displayed (after clicking Submit) if the
entered value is incorrect.
After changing the IP address, you must reset the device.
Subnet Mask
Subnet mask of the device. Enter the subnet mask in dotted-decimal
notation, for example, 255.255.0.0.
Notes:
A warning message is displayed (after clicking Submit) if the
entered value is incorrect.
After changing the subnet mask, you must reset the device.
Default Gateway Address
IP address of the default Gateway used by the device. Enter the IP
address in dotted-decimal notation, for example, 10.8.0.1.
Notes:
A warning message is displayed (after clicking Submit) if the
entered value is incorrect.
After changing the default Gateway IP address, you must reset the
device.
For detailed information on multiple routers support, refer to ''Multiple
Routers Support'' on page 449.
OAM Network Settings (Available only in Multiple IP and Dual IP modes.)
IP Address
[LocalOAMIPAddress]
The device's source IP address in the operations, administration,
maintenance, and provisioning (OAMP) network.
The default value is 0.0.0.0.
Subnet Mask
[LocalOAMSubnetMask]
The device's subnet mask in the OAMP network.
The default subnet mask is 0.0.0.0.
Default Gateway Address
[LocalOAMDefaultGW]
N/A. Use the IP Routing table instead (refer to ''Configuring the IP
Routing Table'' on page 75).