User`s manual

Version 5.4 515 May 2008
SIP User's Manual 13. Installing Windows XP on the OSN Server
13.2.4 Stage 4: Cabling the Mediant 1000 OSN Server
The procedure below describes the cabling for installing Windows.
¾ To cable the OSN server, take these 3 steps:
1. Connect the CM module's (located on the Mediant 1000 front panel) RS-232 port to a
PC (DB-9 connector), using the RS-232 serial cable.
2. Connect the CM module's USB port to a USB hub, using the USB cable.
3. Connect an external CD-ROM drive and a keyboard to the USB hub.
Figure 13-10: Mediant 1000 Front Panel OSN Server Connections
13.2.5 Stage 5: Booting and Installing
Once you have cabled the Mediant 1000 OSN Server (as described in 'Stage 4: Cabling
the Mediant 1000 OSN Server' on page 515), you can boot and install Windows XP.
¾ To boot and install, take these 5 steps:
1. Start HyperTerminal on the computer and set the baud rate to 115200, 8N1.
2. Power up Mediant 1000; HyperTerminal displays startup messages. There are three
possible scenarios: