User`s manual

Version 5.4 457 May 2008
SIP User's Manual 8. Networking Capabilities
Below is an example of an ini file containing VLAN and Multiple IPs parameters:
; Interface Table Configuration:
[InterfaceTable]
FORMAT InterfaceTable_Index = InterfaceTable_ApplicationTypes,
InterfaceTable_IPv6InterfaceMode, InterfaceTable_IPAddress,
InterfaceTable_PrefixLength, InterfaceTable_Gateway,
InterfaceTable_VlanID, InterfaceTable_InterfaceName;
InterfaceTable 0 = 0, 0, 10.31.174.50, 16, 0.0.0.0, 4, OAMP;
InterfaceTable 0 = 1, 0, 10.33.174.50, 16, 10.33.0.1, 6, Media;
InterfaceTable 0 = 2, 0, 10.32.174.50, 16, 0.0.0.0, 5, Control;
[\InterfaceTable]
; VLAN related parameters:
VlanMode = 1
VlanNativeVlanId=4
; Routing Table Configuration:
; IP Routing table parameters
RoutingTableDestinationsColumn = 130.33.4.6, 83.4.87.6
RoutingTableDestinationMasksColumn = 255.255.255.255 ,
255.255.255.0
RoutingTableGatewaysColumn = 10.32.0.1 , 10.31.0.1
RoutingTableInterfacesColumn = 2,0
RoutingTableHopsCountColumn = 20,20
; Class Of Service parameters:
VlanNetworkServiceClassPriority = 7
VlanPremiumServiceClassMediaPriority = 6
VlanPremiumServiceClassControlPriority = 6
VlanGoldServiceClassPriority = 4
VlanBronzeServiceClassPriority = 2
NetworkServiceClassDiffServ = 48
PremiumServiceClassMediaDiffServ = 46
PremiumServiceClassControlDiffServ = 40
GoldServiceClassDiffServ = 26
BronzeServiceClassDiffServ = 10
; Application Type for applications:
EnableDNSasOAM = 1
EnableSCTPasControl = 1
EnableNTPasOAM = 1
2. Use the BootP/TFTP utility (refer to the Product Reference Manual) to load and burn
the firmware version and the ini file you prepared in the previous step to the device
(multiple IPs and VLANs support is available only when the firmware is burned to
flash).
3. Reset the device after disabling it on the BootP/TFTP utility.