User`s manual

SIP User's Manual 382 Document #: LTRT-83303
Mediant 1000 & Mediant 600
ini File Parameter Description
KeyBlindTransfer
Keypad sequence that activates blind transfer for Tel-to-IP calls. There
are two possible scenarios:
 Option 1: After this sequence is dialed, the current call is put on hold
(using Re-INVITE), a dial tone is played to the B-channel, and then
phone number collection starts.
 Option 2: A Hook-Flash is pressed, the current call is put on hold, a
dial tone is played to the B-channel, and then digit collection starts.
After this sequence is identified, the device continues the collection
of the destination phone number.
For both options, after the phone number is collected, it's sent to the
transferee in a SIP REFER request (without a Replaces header). The
call is then terminated and a confirmation tone is played to the B-
channel. If the phone number collection fails due to a mismatch, a
reorder tone is played to the B-channel.
Note: It is possible to configure whether the KeyBlindTransfer code is
added as a prefix to the dialed destination number, by using the
parameter KeyBlindTransferAddPrefix.
KeyBlindTransferAddPrefi
x
Determines whether the device adds the Blind Transfer code
(KeyBlindTransfer) to the dialed destination number.
 [0] Disable (default).
 [1] Enable.
Note: This parameter is applicable to FXO and FXS interfaces.
MinFlashHookTime
For a description of this parameter, refer to "Configuring the Hook-Flash
Settings" on page 94.
Note: This parameter is applicable only to Mediant 1000.
FlashHookOption
For a description of this parameter, refer to DTMF & Dialing Parameters
on page 160.
Note: This parameter is applicable only to Mediant 1000.
FlashHookPeriod
For a description of this parameter, refer to "Configuring the Hook-Flash
Settings" on page 94.
Note: This parameter is applicable only to Mediant 1000.
VQMonEnable
For a description of this parameter, refer to "Configuring the RTP /
RTCP Settings" on page 88.
RTCPInterval
For a description of this parameter, refer to "Configuring the RTP /
RTCP Settings" on page 88.
DisableRTCPRandomize
For a description of this parameter, refer to "Configuring the RTP /
RTCP Settings" on page 88.
RTCPXRESCTransportTyp
e
Determines the transport layer used for outgoing SIP dialogs initiated
by the device to the RTCP-XR Collection Server.
 [-1] Not Configured (default)
 [0] UDP
 [1] TCP
 [2] TLS
Note: When set to ‘Not Configured’, the value of the parameter
SIPTransportType is used.