User`s manual

Version 5.4 369 May 2008
SIP User's Manual 4. ini File Configuration
ini File Parameter Description
SwapTel2IPCalled&Calling
Numbers
If enabled, the device swaps the calling and called numbers received
from the Tel side. The INVITE message contains the swapped numbers.
Applicable for Tel-to-IP calls.
 [0] = Disabled (default)
 [1] = Swap calling and called numbers
AddTON2RPI
For a description of this parameter, refer to ''SIP General Parameters''
on page 134.
NumberMapTel2IP
This ini file table parameter manipulates manipulates the destination
number of Tel-to-IP calls. The format of this parameter is as follows:
[NumberMapTel2Ip]
FORMAT NumberMapTel2Ip_Index =
NumberMapTel2Ip_DestinationPrefix,
NumberMapTel2Ip_SourcePrefix,
NumberMapTel2Ip_SourceAddress, NumberMapTel2Ip_NumberType,
NumberMapTel2Ip_NumberPlan,
NumberMapTel2Ip_RemoveFromLeft,
NumberMapTel2Ip_RemoveFromRight,
NumberMapTel2Ip_LeaveFromRight, NumberMapTel2Ip_Prefix2Add,
NumberMapTel2Ip_Suffix2Add,
NumberMapTel2Ip_IsPresentationRestricted;
[\NumberMapTel2Ip]
Where,
 DestinationPrefix = Destination number prefix.
 SourcePrefix = Source number prefix.
 SourceAddress = N/A.
 NumberType = Number Type used in RPID header.
 NumberPlan = Number Type used in RPID header.
 RemoveFromLeft = Number of stripped digits from the left.
 RemoveFromRight = Number of stripped digits from the right.
 LeaveFromRight = Number of remaining digits from the right.
 Prefix2Add = String to add as prefix.
 Suffix2Add = String to add as suffix.
 IsPresentationRestricted = N/A (set to $$).
For example:
[NumberMapTel2Ip]
NumberMapTel2Ip 0 = 01,$$,*,0,0,2,$$,$$,971,$$,$$;
NumberMapTel2Ip 1 = 10,10,*,255,255,3,0,5,100,$$,255;
[\NumberMapTel2Ip]
Notes:
 RemoveFromLeft, RemoveFromRight, Prefix2Add, Suffix2Add,
LeaveFromRight, NumberType, and NumberPlan are applied if the
called and calling numbers match the DestinationPrefix and
SourcePrefix conditions.
 The manipulation rules are executed in the following order:
RemoveFromLeft, RemoveFromRight, LeaveFromRight, Prefix2Add,
and Suffix2Add.
 Parameters can be skipped by using two dollar signs ('$$').
 Number Plan and Type can optionally be used in Remote Party ID