User`s manual

ManualsBrandsAudioCodes ManualsComputer equipmentMediant 600

361

362

363

364

365

366

367

368

369

370

Version 5.4 361 May 2008

SIP User's Manual 4. ini File Configuration

ini File Parameter Description

BlindTransferDisconne

ctTimeout

Defines the duration (in milliseconds) for which the device waits for a

disconnection from the Tel side after the Blind Transfer Code

(KeyBlindTransfer) has been identified. When this timer expires, a SIP

REFER message is sent toward the IP side. If this parameter is set to 0,

the REFER message is immediately sent.

The valid range is 0 to 1,000,000. The default is 0.

Note: This parameter is applicable only to Mediant 1000.

RejectAnonymousCallP

erPort

This ini file table parameter determines whether the device rejects

incoming anonymous calls on FXS interfaces. The format of this parameter

is as follows:

[RejectAnonymousCallPerPort]

FORMAT RejectAnonymousCallPerPort_Index =

RejectAnonymousCallPerPort_Enable, RejectAnonymousCallPerPort_Port,

RejectAnonymousCallPerPort_Module;

[\RejectAnonymousCallPerPort]

Where,

 Enable = accept [0] (default) or reject [1] incoming anonymous calls.

 Port = Port number.

 Module = Module number.

For example:

[RejectAnonymousCallPerPort]

RejectAnonymousCallPerPort 0 = 0,1,$$;

RejectAnonymousCallPerPort 1 = 1,2,$$;

[\RejectAnonymousCallPerPort]

If enabled, when a device's FXS interface receives an anonymous call, it

responds with a 433 (Anonymity Disallowed) SIP response.

Notes:

 This parameter is applicable only to FXS interfaces.

 This parameter is per FXS port.

 This parameter can appear up to 24 times.

 The double dollar ($$) symbol represents the default value.

 For an explanation on using ini file table parameters, refer to ''Structure

of ini File Table Parameters'' on page 293.

IsTwoStageDial