User`s manual

Version 5.4 357 May 2008
SIP User's Manual 4. ini File Configuration
ini File Parameter Description
For example:
[TargetOfChannel]
TargetOfChannel 1 = 1001,1,0,1; (Automatic dialing on Port 1, Module 1)
[\TargetOfChannel]
Notes:
 The indexing of this ini file table parameter starts at 1.
 The numbering of channels starts at 0.
 Define this parameter for each device port that implements Automatic
Dialing.
 To configure the Automatic Dialing Table using the Web interface, refer
to ''Automatic Dialing'' on page 220.
 For an explanation on using ini file table parameters, refer to ''Structure
of ini File Table Parameters'' on page 293.
CallerDisplayInfo
This ini file table parameter enables the device to send Caller ID
information to IP when a call is made. The format of this parameter is as
follows:
[CallerDisplayInfo]
FORMAT CallerDisplayInfo_Index = CallerDisplayInfo_DisplayString,
CallerDisplayInfo_IsCidRestricted, CallerDisplayInfo_Port,
CallerDisplayInfo_Module;
[\CallerDisplayInfo]
Where,
 DisplayString = Caller ID string.
 IsCidRestricted = Restriction - [0] not restricted (default); [1] restricted.
 Port = Port number.
 Module = Module number (0 - 5).
For example:
[CallerDisplayInfo]
CallerDisplayInfo 1 = Susan C.,0,1,0; (Caller ID on port 1 of first module)
[\CallerDisplayInfo]
Notes:
 The indexing of this ini file table parameter starts at 1.
 The numbering of channels starts with 0.
 To configure Caller Display Information using the Web interface, refer to
''Caller ID'' on page 221.
 For a description on using ini file table parameters, refer to ''Structure of
ini File Table Parameters'' on page 293.