User`s manual

SIP User's Manual 356 Document #: LTRT-83303
Mediant 1000 & Mediant 600
ini File Parameter Description
ChargeCode
This ini file table parameter configures metering tones (and their time
intervals) that the device's FXS interface generates to the Tel side.
The format of this parameter is as follows:
[ChargeCode]
FORMAT ChargeCode_Index = ChargeCode_EndTime1,
ChargeCode_PulseInterval1, ChargeCode_PulsesOnAnswer1,
ChargeCode_EndTime2, ChargeCode_PulseInterval2,
ChargeCode_PulsesOnAnswer2, ChargeCode_EndTime3,
ChargeCode_PulseInterval3, ChargeCode_PulsesOnAnswer3,
ChargeCode_EndTime4, ChargeCode_PulseInterval4,
ChargeCode_PulsesOnAnswer4;
[\ChargeCode]
Where,
 EndTime = Period (1 - 4) end time.
 PulseInterval = Period (1 - 4) pulse interval.
 PulsesOnAnswer = Period (1 - 4) pulses on answer.
For example:
[ChargeCode]
ChargeCode 1 = 7,30,1,14,20,2,20,15,1,0,60,1;
ChargeCode 2 = 5,60,1,14,20,1,0,60,1;
ChargeCode 3 = 0,60,1;
ChargeCode 0 = 6, 3, 1, 12, 2, 1, 18, 5, 2, 0, 2, 1;
[\ChargeCode]
Notes:
 The parameter can appear up to 25 times (i.e., up to 25 different
metering rules can be defined).
 To configure the Charge Codes table using the Web interface, refer to
"Charge Codes Table" on page 183.
 For an explanation on configuration using ini file table parameters, refer
to ''Structure of ini File Table Parameters'' on page 293.
TargetOfChannel
This ini file table parameter defines telephone numbers that are
automatically dialed when a specific port is used. The format of this
parameter is as follows:
[TargetOfChannel]
FORMAT TargetOfChannel_Index = TargetOfChannel_Destination,
TargetOfChannel_Type, TargetOfChannel_Port,
TargetOfChannel_Module;
[\TargetOfChannel]4
Where,
 Destination = Destination phone number.
 Type:
[1] = Destination phone number is automatically dialed if phone is off-
hooked (for FXS interface) or ring signal is applied to port (FXO
interface).
[0] = automatic dialing is disabled.
[2] = enables Hotline - when a phone is off- hooked and no digit is
pressed for HotLineToneDuration, the destination phone number is
automatically dialed.
 Port = Port number.
 Module = Module number (0 - 5).