User`s manual

Version 5.4 353 May 2008
SIP User's Manual 4. ini File Configuration
ini File Parameter Description
CASAddressingDelimite
rs
Determines if delimiters are added to the dialed address or dialed ANI
parameters.
 [0] = Disable (default)
 [1] = Enable
When this parameter is enabled, delimiters such as '*', '#', and 'ST' are
added to the dialed address or dialed ANI parameters. When it is
disabled, the address and ANI strings remain without delimiters.
Note: This parameter is not applicable to BRI interfaces.
CASDelimitersPaddingU
sage
Defines the digits string delimiter padding usage per trunk.
 [0] (default) = default address string padding: '*XXX#' (where XXX is
the digit string that begins with '*' and ends with '#', when using
padding).
 [1] = special use of asterisks delimiters: '*XXX*YYY*' (where XXX is
the address, YYY is the source phone number, and '*' is the only
delimiter padding).
Note: This parameter is not applicable to BRI interfaces.
CasStateMachineGenera
teDigitOnTime
For a description of this parameter, refer to ''Configuring the CAS State
Machines'' on page 109.
CasStateMachineGenera
teInterDigitTime
For a description of this parameter, refer to ''Configuring the CAS State
Machines'' on page 109.
CasStateMachineDTMF
MaxOnDetectionTime
For a description of this parameter, refer to ''Configuring the CAS State
Machines'' on page 109.
CasStateMachineDTMF
MinOnDetectionTime
For a description of this parameter, refer to ''Configuring the CAS State
Machines'' on page 109.
CasStateMachineMaxNu
mOfIncomingAddressDi
gits
For a description of this parameter, refer to ''Configuring the CAS State
Machines'' on page 109.
CasStateMachineMaxNu
mOfIncomingANIDigits
For a description of this parameter, refer to ''Configuring the CAS State
Machines'' on page 109.
CasStateMachineCollect
ANI
For a description of this parameter, refer to ''Configuring the CAS State
Machines'' on page 109.
CasStateMachineDigitSi
gnalingSystem
For a description of this parameter, refer to ''Configuring the CAS State
Machines'' on page 109.
EnableDSPIPMDetectors
Enables or disables the device's DSP detectors.
 [0] = Disable (default).
 [1] = Enable.
Notes:
 The device's Feature Key should contain the 'IPMDetector' DSP
option.
 When enabled (1), the number of available channels is reduced.
XChannelHeader
For a description of this parameter, refer to Advanced Parameters on
page 166.
AddIEinSetup
For a description of this parameter, refer to ''Configuring the Digital
Gateway Parameters'' on page 235.