User`s manual

Version 5.4 347 May 2008
SIP User's Manual 4. ini File Configuration
ini File Parameter Description
ISDN Flexible Behavior Parameters
ISDN protocol is implemented in different Switches / PBXs by different vendors. Several
implementations vary a little from the specification. Therefore, to provide a flexible interface that
supports these ISDN variants, the ISDN behavior parameters are used.
ISDNInCallsBehavior
For a description of this parameter, refer to "Configuring the Trunk
Settings" on page 96.
ISDNIBehavior
For a description of this parameter, refer to "Configuring the Trunk
Settings" on page 96.
ISDNGeneralCCBehavior
For a description of this parameter, refer to "Configuring the Trunk
Settings" on page 96.
ISDNOutCallsBehavior
For a description of this parameter, refer to "Configuring the Trunk
Settings" on page 96.
ISDNIBehavior_x
Same as the description for parameter ISDNIBehavior, but for a specific
trunk ID.
ISDNInCallsBehavior_x
Same as the description for parameter ISDNInCallsBehavior, for a
specific trunk ID.
ISDNOutCallsBehavior_x
Same as the description for parameter ISDNOutCallsBehavior, but for a
specific trunk ID.
PlayRBTone2Tel
For a description of this parameter, refer to ''SIP General Parameters'' on
page 134.
PlayRBTone2IP
For a description of this parameter, refer to ''SIP General Parameters'' on
page 134.
ProgressIndicator2IP
For a description of this parameter, refer to ''Advanced Parameters'' on
page 166.
TimeForReorderTone
For a description of this parameter, refer to Configuring the FXO
Parameters on page 248.
ISDNDisconnectOnBusyT
one
Determines whether a call is disconnected upon detection of a busy tone.
 [0] No = Do not disconnect call upon detection of busy tone.
 [1] Yes = Disconnect call upon detection of busy tone (default).
Note: This parameter is applicable only to ISDN protocols. For CAS, use
the parameter DisconnectOnBusyTone.
DisconnectOnBusyTone
For a description of this parameter, refer to Configuring the FXO
Parameters on page 248
EnableVoiceDetection
For a description of this parameter, refer to Configuring the FXO
Parameters on page 248.
 [1] = The device sends 200 OK (to INVITE) messages when
speech/fax/modem is detected.
 [0] = The device sends 200 OK messages immediately after the
device finishes dialing (default).
Usually this feature is used only when early media (EnableEarlyMedia) is
used to establish voice path before the call is answered.
Notes:
 To activate this feature, set EnableDSPIPMDetectors to 1.
 This feature is applicable only when the protocol type is CAS.