User`s manual

SIP User's Manual 334 Document #: LTRT-83303
Mediant 1000 & Mediant 600
ini File Parameter Description
3WayConferenceMode
Defines the mode of operation when the 3-Way Conference feature is
used.
 [0] = Conference-initiating INVITE (sent by the device), uses the
ConferenceID concatenated with a unique identifier as the Request-
UR (default).
 [1] = Conference-initiating INVITE (sent by the device), uses only the
ConferenceID as the Reques-URI.
If 3wayConferenceMode is set to 0, the Conference-initiating INVITE
sent by the device uses the ConferenceID concatenated with a unique
identifier as the Request-URI. This same Request-URI is set as the
Refer-To header value in the REFER messages that are sent to the two
remote parties.
If 3wayConferenceMode is set to 1, the Conference-initiating INVITE
sent by the device only uses the ConferenceID as the Reques-URI. The
media server sets the Contact header of the 200 OK response to the
actual unique identifier (Conference URI) to be used by the participants.
This Conference URI is included (by the device) in the Refer-To header
value in the REFER messages sent by the device to the remote parties.
The remote parties join the conference by sending INVITE messages to
the media server using this conference URI.
Note: This parameter is applicable only to Mediant 1000.
Enable3WayConference
For a description of this parameter, refer to "Supplementary Services"
on page 176.
Note: This parameter is applicable only to Mediant 1000.
ConferenceCode
For a description of this parameter, refer to "Supplementary Services"
on page 176.
Note: This parameter is applicable only to Mediant 1000.
ConferenceID
For a description of this parameter, refer to "Supplementary Services"
on page 176.
Note: This parameter is applicable only to Mediant 1000.
BipOnConference
Determines whether a beep is played when a new participant joins a
conference and when a participant leaves a conference (in the latter
case, a beep of a different pitch is heard).
 [0] = Beep is disabled.
 [1] = Beep is enabled (default).
Note: This parameter is applicable only to Mediant 1000.
Send180ForCallWaiting
Determines the SIP response code for indicating call waiting.
 [0] = Use 182 Queued response to indicate call waiting (default).
 [1] = Use 180 Ringing response to indicate call waiting.
HookFlashCode
For a description of this parameter, refer to ''Supplementary Services''
on page 176.
UseSIPURIForDiversionHe
ader
Sets the URI format in the SIP Diversion header.
 [0] = 'tel:' (default)
 [1] = 'sip:'