User`s manual

SIP User's Manual 330 Document #: LTRT-83303
Mediant 1000 & Mediant 600
ini File Parameter Description
UseAORInReferToHeader
Defines the source for the SIP URI set in the Refer-To header of
outgoing REFER messages.
 [0] = Use SIP URI from Contact header of the initial call (default).
 [1] = Use SIP URI from To/From header of the initial call.
UseTelURIForAssertedID
For a description of this parameter, refer to ''SIP General Parameters''
on page 134.
EnableRPIheader
For a description of this parameter, refer to ''SIP General Parameters''
on page 134.
IsUserPhone
For a description of this parameter, refer to ''SIP General Parameters''
on page 134.
IsUserPhoneInFrom
For a description of this parameter, refer to ''SIP General Parameters''
on page 134.
IsUseToHeaderAsCalledN
umber
Determines whether the called number is set in the user part of the To
header.
 [0] = Sets the destination number to the user part of the Request-
URI for IP-to-Tel calls, and sets the Contact header to the source
number for Tel-to-IP calls (default).
 [1] = Sets the destination number to the user part of the To header
for IP-to-Tel calls, and sets the Contact header to the username
parameter for Tel-to-IP calls.
EnableHistoryInfo
For a description of this parameter, refer to ''SIP General Parameters''
on page 134.
SIPSubject
For a description of this parameter, refer to ''SIP General Parameters''
on page 134.
MultiPtimeFormat
For a description of this parameter, refer to ''SIP General Parameters''
on page 134.
EnableReasonHeader
For a description of this parameter, refer to ''SIP General Parameters''
on page 134.
EnableSemiAttendedTran
sfer
For a description of this parameter, refer to ''SIP General Parameters''
on page 134.
EnablePtime
Determines whether the ptime header is included in the SDP.
 [0] = Remove the ptime header from SDP.
 [1] = Include the ptime header in SDP (default).
EnableUserInfoUsage
For a description of this parameter, refer to ''Advanced Parameters'' on
page 166.
HandleReasonHeader
Determines whether the device uses the value of the incoming SIP
Reason header for Release Reason mapping.
 [0] Disregard Reason header in incoming SIP messages.
 [1] Use the Reason header value for Release Reason mapping
(default).