User`s manual

Version 5.4 311 May 2008
SIP User's Manual 4. ini File Configuration
ini File Parameter Description
Serial Parameters
DisableRS232
 [0] = RS-232 serial port is enabled (default).
 [1] = RS-232 serial port is disabled.
The RS-232 serial port can be used to change the networking
parameters and view error / notification messages.
For information on establishing a serial communications link with the
device, refer to the device's Fast Track.
SerialBaudRate
Determines the value of the RS-232 baud rate.
The valid range is any value. It is recommended to use the following
standard values: 1200, 2400, 9600 (default), 14400, 19200, 38400,
57600, 115200.
SerialData
Determines the value of the RS-232 data bit.
 [7] = 7-bit.
 [8] = 8-bit (default).
SerialParity
Determines the value of the RS-232 polarity.
 [0] = None (default).
 [1] = Odd.
 [2] = Even.
SerialStop
Determines the value of the RS-232 stop bit.
 [1] = 1-bit (default).
 [2] = 2-bit.
SerialFlowControl
Determines the value of the RS-232 flow control.
 [0] = None (default).
 [1] = Hardware.
4.4.3 Web and Telnet Parameters
Table 4-3: Web and Telnet Parameters
ini File Parameter Description
WebAccessList_x
Defines up to ten IP addresses that are permitted to access the device's
Web interface and Telnet interfaces. Access from an undefined IP
address is denied. This security feature is inactive (i.e., the device can be
accessed from any IP address) when the table is empty.
For example:
WebAccessList_0 = 10.13.2.66
WebAccessList_1 = 10.13.77.7
The default value is 0.0.0.0 (i.e., the device can be accessed from any IP
address).
For defining the Web and Telnet Access list using the Web interface,
refer to ''Configuring the Web and Telnet Access List'' on page 114.
WebRADIUSLogin
For a description of this parameter, refer to ''Configuring the General
Security Settings'' on page 123.