User`s manual

ManualsBrandsAudioCodes ManualsComputer equipmentMediant 600

301

302

303

304

305

306

307

308

309

310

Version 5.4 307 May 2008

SIP User's Manual 4. ini File Configuration

ini File Parameter Description

HeartBeatDestIP

Destination IP address (in dotted format notation) to which the device

sends proprietary UDP 'ping' packets.

The default IP address is 0.0.0.0.

HeartBeatDestPort

Destination UDP port to which the heartbeat packets are sent.

The range is 0 to 64000. The default is 0.

HeartBeatIntervalmsec

Delay (in msec) between consecutive heartbeat packets.

 [10] = 100000.

 [-1] = disabled (default).

EnableRAI

 [0] = Disable RAI (Resource Available Indication) service (default).

 [1] = Enable RAI service.

If RAI is enabled, an SNMP 'acBoardCallResourcesAlarm' Alarm Trap is

sent if device's busy endpoints exceed a predefined (configurable)

threshold.

RAIHighThreshold

High threshold percentage of total calls that are active (busy endpoints).

When the percentage of the device's busy endpoints exceeds this High

Threshold, the device sends the SNMP acBoardCallResourcesAlarm

Alarm Trap with a 'major' Alarm Status.

The range is 0 to 100. The default value is 90.

Note: The percentage of busy endpoints is calculated by dividing the

number of busy endpoints by the total number of “enabled” endpoints

(trunks are physically connected and synchronized with no alarms and

endpoints are defined in the Trunk Group table).

RAILowThreshold

Low threshold percentage of total calls that are active (busy endpoints).

When the percentage of the device's busy endpoints falls below this Low

Threshold, the device sends an SNMP acBoardCallResourcesAlarm

Alarm Trap with a 'cleared' Alarm Status.

The range is 0 to 100%. The default value is 90%.

RAILoopTime

Time interval (in seconds) that the device periodically checks call

resource availability.

The valid range is 1 to 200. The default is 10.

Disconnect Supervision Parameters

TelConnectCode