User`s manual

SIP User's Manual 260 Document #: LTRT-83303
Mediant 1000 & Mediant 600
Table 3-63: SNMP V3 Users Parameters
Parameter Description
Index
[SNMPUsers_Index]
The table index.
The valid range is 0 to 9.
Username
[SNMPUsers_Username]
Name of the SNMP v3 user. This name must be unique.
AuthProtocol
[SNMPUsers_AuthProtocol]
Authentication protocol of the SNMP v3 user.
 0 = None (default)
 1 = MD5
 2 = SHA-1
PrivProtocol
[SNMPUsers_PrivProtocol]
Privacy protocol of the SNMP v3 user.
 0 = none (default)
 1 = DES
 2 = 3DES
 3 = AES128
 4 = AES192
 5 = AES256
AuthKey
[SNMPUsers_AuthKey]
A
uthentication key. Keys can be entered in the form of a text password
or long hex string. Keys are always persisted as long hex strings and
keys are localized.
PrivKey
[SNMPUsers_PrivKey]
Privacy key. Keys can be entered in the form of a text password or
long hex string. Keys are always persisted as long hex strings and
keys are localized.
Group
[SNMPUsers_Group]
The group with which the SNMP v3 user is associated.
 0 = read-only group (default)
 1 = read-write group
 2 = trap group
Note: All groups can be used to send traps.
3.5.1.1.4 Configuring SNMP Trusted Managers
The 'SNMP Trusted Managers' page allows you to configure up to five SNMP Trusted
Managers, based on IP addresses. By default, the SNMP agent accepts SNMP Get and
Set requests from any IP address, as long as the correct community string is used in the
request. Security can be enhanced by using Trusted Managers, which is an IP address
from which the SNMP agent accepts and processes SNMP requests.
¾ To configure the SNMP Trusted Managers, take the following 6
steps:
1. Access the 'Management Settings' page, as described in ''Configuring the
Management Settings'' on page 254.