User`s manual

SIP User's Manual 250 Document #: LTRT-83303
Mediant 1000 & Mediant 600
Parameter Description
Ring Detection Timeout
[sec]
[FXOBetweenRingTime]
Defines the timeout (in seconds) for detecting the second ring after the first
detected ring.
If automatic dialing is not used and Caller ID is enabled, the device seizes
the line after detection of the second ring signal (allowing detection of
caller ID sent between the first and the second rings). If the second ring
signal is not received within this timeout, the device doesn't initiate a call to
IP.
If automatic dialing is used, the deviceinitiates a call to IP when the ringing
signal is detected. The FXO line is seized only if the remote IP party
answers the call. If the remote party doesn't answer the call and the
second ring signal is not received within this timeout, the device releases
the IP call.
This parameter is typically set to between 5 and 8. The default is 8.
Note: This parameter is applicable only for Tel-to-IP calls.
Reorder Tone Duration
[sec]
[TimeForReorderTone]
For Analog: Busy or Reorder tone duration (in seconds) that the device
plays before releasing the line.
The valid range is 0 to 254. The default is 0 seconds.
Typically, after playing a Reorder / Busy tone for the specified duration, the
device starts playing an Offhook Warning tone.
Notes:
 Selection of Busy or Reorder tone is performed according to the release
cause received from IP.
 Refer also to the parameter CutThrough, described in ''Advanced
Parameters'' on page 166.
For Digital: Busy or Reorder Tone duration (in seconds) that the CAS
device plays before releasing the line.
The valid range is 0 to 254. The default value is 10.
This parameter is also applicable for ISDN if PlayBusyTone2ISDN = 2. The
selection of Busy or Reorder tone is done according to the release cause
received from IP.
Answer Supervision
[EnableVoiceDetection]
Enables sending of 200 OK upon detection of speech, fax, or modem.
 [1] Yes = device sends 200 OK (to INVITE) messages when
speech/fax/modem is detected.
 [0] No = 200 OK is sent only once the device completes dialing
(default).
Typically, this feature is used only when early media (EnableEarlyMedia) is
used to establish the voice path before the call is answered.
Note: This feature is applicable only for one-stage dialing.
Rings before Detecting
Caller ID
[RingsBeforeCallerID]
Determines the number of rings before the device starts detecting Caller
ID.
 [0] 0 = Before first ring.
 [1] 1 = After first ring (default).
 [2] 2 = After second ring.
Send Metering Message
to IP
[SendMetering2IP]
N/A.