User`s manual

SIP User's Manual 242 Document #: LTRT-83303
Mediant 1000 & Mediant 600
3.4.5.9 Configuring the IPmedia Parameters
The 'IPmedia Parameters' page allows you to configure the IP media parameters.
Note: The 'IPmedia Parameters' page is applicable only to Mediant 1000. The
'IPmedia Parameters' page is Feature Key dependant and therefore is
available only if included in the device's Feature Key (refer to 'Updating the
Software Upgrade Key' on page 268).
¾ To configure the IP media parameters, take these 4 steps:
1. Open the 'IPmedia Parameters' page (Configuration tab > Protocol Configuration
menu > IP Media submenu > IPMedia Parameters page item).
Figure 3-97: IPmedia Parameters Page
2. Configure the IP media parameters according to the table below.
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, refer to ''Saving Configuration'' on page 265.
Table 3-55: IP Media Configuration Parameters
ini File Field Name
Web Parameter Name
Valid Range and Description
Number of Media
Channels
[MediaChannels]
The number of DSP channels that are allocated for IP conferencing, IP
streaming, and IP transcoding (other DSP channels can be used for
PSTN device).
The maximum value of Media Channels depends on the number of
installed Media Processing modules (MPM): 1 module = 20 channels; 2
modules = 60; 3 modules = 100. The default value is 0.
Enable Voice Streaming
[EnableVoiceStreaming]
Enables/disables the HTTP Voice Streaming application (play / record).
 [0] Disable = Voice Streaming is disabled (default).
 [1] Enable = Voice Streaming is enabled.