User`s manual

Version 5.4 237 May 2008
SIP User's Manual 3. Web-Based Management
Parameter Description
Send Screening Indicator to IP
[ScreeningInd2IP]
Overrides the calling party's number (CPN) screening indication in
the received ISDN SETUP message for Tel-to-IP calls.
 [-1] Not Configured = not configured (interworking from ISDN to
IP) or set to 0 for CAS (default).
 [0] User Provided = CPN set by user, but not screened
(verified).
 [1] User Passed = CPN set by user, verified and passed.
 [2] User Failed = CPN set by user, and verification failed.
 [3] Network Provided = CPN set by network.
Note: Applicable only if Remote Party ID (RPID) header is
enabled.
Send Screening Indicator to ISDN
[ScreeningInd2ISDN]
Overrides the screening indicator of the calling party's number for
IP-to-Tel ISDN calls.
 [-1] Not Configured = Not configured (interworking from IP to
ISDN) (default).
 [0] User Provided = user provided, not screened.
 [1] User Passed = user provided, verified and passed.
 [2] User Failed = user provided, verified and failed.
 [3] Network Provided = network provided.
Add IE in SETUP
[AddIEinSetup]
Adds an optional Information Element (IE) data (in hex format) to
ISDN SETUP messages. For example, to add IE
'0x20,0x02,0x00,0xe1', enter the following value for this parameter:
'200200e1'.
Note: This IE is sent from the Trunk Group IDs defined by the
parameter SendIEonTG.
Trunk Groups to Send IE
[SendIEonTG]
Defines Trunk Group IDs (up to 50 characters) from where the
optional ISDN IE defined by the parameter AddIEinSetup is sent.
For example: '1,2,4,10,12,6'.
Enable User-to-User IE for Tel to
IP
[EnableUUITel2IP]
Enables ISDN PRI-to-SIP interworking.
 [0] Disable = Disabled (default).
 [1] Enable = Enable transfer of User-to-User Information
Element (UUIE) from PRI to SIP.
The device supports the following ISDN PRI-to-SIP interworking:
SETUP to SIP INVITE, CONNECT to SIP 200 OK, USER
INFORMATION to SIP INFO, ALERT to SIP 18x response, and
DISCONNECT to SIP BYE response messages.
Note: The interworking of User-to-User IE to SIP INFO is
supported only on the 4ESS PRI variant.