User`s manual

Version 5.4 233 May 2008
SIP User's Manual 3. Web-Based Management
¾ To configure Accounts, take these 5 steps:
1. Open the 'Account Table' page (Configuration tab > Protocol Configuration menu >
Trunk/IP Group submenu > Account Table page item).
Figure 3-95: Account Table Page
2. To add an Account, in the 'Add' field, enter the desired table row index, and then click
Add. A new row appears.
3. Configure the Account parameters according to the table below.
4. Click the Apply button to save your changes.
5. To save the changes, refer to ''Saving Configuration'' on page 265.
Note: For a description of the web interface's table command buttons (e.g.,
Duplicate and Delete), refer to ''Working with Tables'' on page 36.
Table 3-53: Account Parameters Description
Parameter Description
Served Trunk Group The Trunk Group ID for which the device performs registration and/or
authentication to a destination IP Group (i.e., Serving IP Group).
For Tel-to-IP calls, the ServedTrunkGroup is the source Trunk Group from
where the call initiated. For IP-to-Tel calls, the ServedTrunkGroup is the 'Trunk
Group ID' defined in the 'IP to Trunk Group Routing' table (refer to ''IP to Trunk
Group Routing'' on page 204). For defining Trunk Groups, refer to ''Configuring
the Trunk Group Table'' on page 226.
Serving IP Group The destination Serving IP Group ID (defined in ''Configuring the IP Groups'' on
page 231) to where the REGISTER requests (if enabled) are sent. The actual
destination to where the Trunk Group registers is the IP address defined for the
Proxy Set ID (refer to ''Proxy Sets Table'' on page 153) associated with the
Serving IP Group. This occurs only in the following conditions:
 The parameter 'Registration Mode' is set to 'Per Account' in the 'Trunk
Group Settings' table (refer to ''Configuring the Trunk Group Settings'' on
page 228).
 The parameter 'Register' in this table is set to 1.
In addition, for a SIP call that is identified by both the ServedTrunkGroup and
ServingIPGroup, the username and password for digest authentication defined
in this table is used.
For Tel-to-IP calls, the ServingIPGroup is the destination IP Group defined in
the 'Trunk Group Settings' table or 'Tel to IP Routing' table (refer to ''Tel to IP
Routing Table'' on page 200). For IP-to-Tel calls, the ServingIPGroup is the
'Source IPGroup ID' defined in the 'IP to Trunk Group Routing' table (refer to
''IP to Trunk Group Routing'' on page 204).
Note: If no match is found in the 'Account' table for incoming or outgoing calls,