User`s manual

SIP User's Manual 232 Document #: LTRT-83303
Mediant 1000 & Mediant 600
Table 3-52: IP Group Parameters Description
Parameter Description
IP Group ID The identifying number of the IP Group.
The range is 1-9.
Description Brief string description of the IP Group.
The value range is a string of up to 29 characters. The default is an empty
field.
Proxy Set ID Selects the Proxy Set ID to be associated with the IP Group. All INVITE
messages configured to be 'sent' to the specific IP Group are physically sent
to the IP address associated with the Proxy Set.
The range is 0-5, where 0 is the default Proxy Set.
Note: To configure Proxy Set ID's, refer to ''Proxy Sets Table'' on page 153.
SIP Group Name The request URI host name used in INVITE and REGISTER messages. If not
specified, the value of the global parameter ProxyName (refer to ''Proxy &
Registration Parameters'' on page 146) is used instead.
The value range is a string of up to 49 characters. The default is an empty
field.
Send Invite To Proxy Determines whether INVITE messages are sent to the IP Group.
 Disable (default).
 Enable = INVITE messages as a result of REFER/3xx messages are sent
to the IP Group, overriding the Refer-To/Contact destination.
Always Use Route
Table
Determines the Request URI host name in outgoing INVITE messages.
 Disable (default).
 Enable = The device uses the IP address (or domain name) defined in the
'Tel to IP Routing' table (''Tel to IP Routing Table'' on page 200) as the
Request URI host name in outgoing INVITE messages, instead of the
value entered in the 'SIP Group Name' field.
3.4.5.7.4 Configuring the Account Table
The 'Account Table' page allows you to define accounts per Trunk Groups (referred to as
Served Trunk Group) for registration and/or digest authentication (user name and
password) to a destination IP address (Serving IP Group). The Accounts table can be
used, for example, to register to an Internet Telephony Service Provider (ITSP) on behalf of
an IP-PBX to which the device is connected. The registrations are sent to the Proxy Set ID
(refer to ''Proxy Sets Table'' on page 153) associated with these Serving IP Groups. A
Trunk Group can register to more than one Serving IP Group (e.g., ITSP's), by configuring
multiple entries in this Account table with the same Served Trunk Group, but with different
Serving IP Groups, user name/password, Host Name, and Contact User parameters.
Note: You can also configure the Account table using the ini file table parameter
Account (refer to ''SIP Configuration Parameters'' on page 323).