User`s manual

SIP User's Manual 226 Document #: LTRT-83303
Mediant 1000 & Mediant 600
3.4.5.7 Configuring the Trunk and IP Groups
The Trunk/IP Group menu allows you to configure groups of channels. This submenu
includes the following page items:
 Trunk Group (refer to "Configuring the Trunk Group Table" on page 226)
 Trunk Group Settings (refer to ''Configuring the Trunk Group Settings'' on page 228)
 IP Group Table (refer to ''Configuring the IP Groups'' on page 231)
 Account Table (refer to ''Configuring the Account Table'' on page 232)
3.4.5.7.1 Configuring the Trunk Group Table
The 'Trunk Group Table' page provides you with a table for enabling device channels, by
assigning them telephone numbers, Trunk Groups, and Profiles. Trunk Groups are used for
routing IP-to-Tel calls with common rules. Channels that are not defined are disabled. You
can add up to 24entries in this table.
Note: You can also configure the Trunk Groups using the ini file table parameter
TrunkGroup_x to (refer to ''Number Manipulation and Routing Parameters'' on
page 364).
¾ To configure the Trunk Group table, take these 4 steps:
1. Open the 'Trunk Group Table' page (Configuration tab > Protocol Configuration
menu > Trunk/IP Group submenu > Trunk Group page item).
Figure 3-92: Trunk Group Table Page
2. Configure the Trunk Group according to the table below.
3. Click the Submit button to save your changes.
4. To save the changes to the flash memory, refer to ''Saving Configuration'' on page
265.