User`s manual

SIP User's Manual 224 Document #: LTRT-83303
Mediant 1000 & Mediant 600
3.4.5.6.5 Caller ID Permissions
The 'Caller ID Permissions' page allows you to enable or disable (per port), the Caller ID
generation (for FXS interfaces) and detection (for FXO interfaces). If a port isn't configured,
its Caller ID generation / detection are determined according to the global parameter
EnableCallerID described in ''Supplementary Services'' on page 176.
Notes:
• The 'Caller ID Permissions' page is relevant to FXS and FXO interfaces
and applicable only to Mediant 1000.
• You can also configure the Caller ID Permissions table using the ini file
table parameter EnableCallerID (refer to ''Analog Telephony Parameters''
on page 355).
¾ To configure Caller ID Permissions per port, take these 4 steps:
1. Open the 'Caller ID Permissions' page (Configuration tab > Protocol Configuration
menu > Endpoint Settings submenu > Caller ID Permissions page item).
Figure 3-90: Caller ID Permissions Page
2. From the 'Caller ID' drop-down list, select one of the following:
• 'Enable': Enables Caller ID generation (FXS) or detection (FXO) for the specific
port.
• 'Disable': Caller ID generation (FXS) or detection (FXO) for the specific port is
disabled.
• Not defined: Caller ID generation (FXS) or detection (FXO) for the specific port is
determined according to the parameter 'Enable Caller ID' (described in
''Supplementary Services'' on page 176).
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, refer to ''Saving Configuration'' on page 265.