User`s manual

Version 5.4 221 May 2008
SIP User's Manual 3. Web-Based Management
3.4.5.6.3 Caller Display Information
The 'Caller Display Information' page allows you to enable the device to send Caller ID
information to IP when a call is made. The called party can use this information for caller
identification. The information configured in this page is sent in an INVITE message in the
'From' header. For information on Caller ID restriction according to destination / source
prefixes, refer to ''Configuring the Number Manipulation Tables'' on page 190.
¾ To configure the Caller Display Information, take these 5 steps:
1. Open the 'Caller Display Information' page (Configuration tab > Protocol
Configuration menu > Endpoint Settings submenu > Caller Display Information
page item).
Figure 3-88: Caller Display Information Page
2. In the' Caller ID/Name' field corresponding to the desired port, enter the Caller ID
string (up to 18 characters). Note that when the FXS ports receive 'Private' or
'Anonymous' strings in the From header, it doesn't send the calling name or number to
the Caller ID display.
3. From the 'Presentation' drop-down list, select one of the following:
• 'Allowed' [0] - sends the string defined in the 'Caller ID/Name' field when a Tel-to-
IP call is made using the corresponding device port.
• 'Restricted' [1] - the string defined in the 'Caller ID/Name' field is not sent (refer to
the note below).