User`s manual

Version 5.4 199 May 2008
SIP User's Manual 3. Web-Based Management
Parameter Description
Replace Empty
Destination with B-
channel Phone Number
[ReplaceEmptyDstWith
PortNumber]
Determines whether the internal channel number is used as the destination
number if the called number is missing.
 [0] No (default)
 [1] Yes
Note: Applicable only for Tel-to-IP calls and if the called number is missing.
Add NPI and TON to
Calling Number
[AddNPIandTON2Callin
gNumber]
Determines whether Numbering Plan Indicator (NPI) and Type of
Numbering (TON) are added to the Calling Number for Tel-to-IP calls.
 [0] No = Do not change the Calling Number (default).
 [1] Yes = Add NPI and TON to the Calling Number ISDN Tel-to-IP call.
For example: After receiving a Calling Number of 555, NPI of 1, and TON
of 3, the modified number becomes 13555. This number can later be used
for manipulation and routing.
Add NPI and TON to
Called Number
[AddNPIandTON2Called
Number]
Determines whether NPI and TON are added to the Called Number for Tel-
to-IP calls.
 [0] No = Do not change the Called Number (default).
 [1] Yes = Add NPI and TON to the Called Number of ISDN Tel-to-IP
call.
For example: After receiving a Called Number of 555, NPI of 1 and TON of
3, the modified number becomes 13555. This number can later be used for
manipulation and routing.
IP to Tel Remove
Routing Table Prefix
[RemovePrefix]
Determines whether the device removes the prefix from the destination
number for IP-to-Tel calls.
 [0] No = Don't remove prefix (default)
 [1] Yes = Remove the prefix (defined in the 'IP to Trunk Group Routing'
table - refer to ''IP to Trunk Group Routing'' on page 204) from a
telephone number for an IP-to-Tel call, before forwarding it to Tel.
For example: To route an incoming IP-to-Tel call with destination number
21100, the 'IP to Trunk Group Routing' table is scanned for a matching
prefix. If such a prefix is found (e.g., 21), then before the call is routed to
the corresponding Trunk Group, the prefix (21) is removed from the original
number, and therefore, only 100 remains.
Notes:

A
pplicable only if number manipulation is performed after call routing for
IP-to-Tel calls (i.e., RouteModeIP2Tel parameter is set to 0).
 Similar operation (of removing the prefix) is also achieved by using the
usual number manipulation rules.
Enable Alt Routing Tel to
IP
[AltRoutingTel2IPEnabl
e]
Enables the Alternative Routing feature for Tel-to-IP calls.
 [0] Disable = Disables the Alternative Routing feature (default).
 [1] Enable = Enables the Alternative Routing feature.
 [2] Status Only = The Alternative Routing feature is disabled, but read-
only information on the Quality of Service of the destination IP
addresses is provided.
For information on the Alternative Routing feature, refer to ''Configuring
Alternative Routing (Based on Connectivity and QoS)'' on page 415.