User`s manual

SIP User's Manual 198 Document #: LTRT-83303
Mediant 1000 & Mediant 600
3.4.5.4.1 Routing General Parameters
The 'Routing General Parameters' page allows you to configure the device's IP-to-Tel and
Tel-to-IP routing parameters.
¾ To configure the general routing parameters, take these 4 steps:
1. Open the 'Routing General Parameters' page (Configuration tab > Protocol
Configuration menu > Routing Tables submenu > Routing General Parameters
page item).
2. Configure the general parameters according to the table below.
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, refer to ''Saving Configuration'' on page 265.
Table 3-45: Routing General Parameters Description
Parameter Description
Add Trunk Group ID as
Prefix
[AddTrunkGroupAsPref
ix]
Determines whether the device's Trunk Group ID is added as a prefix to
the destination phone number for Tel-to-IP calls.
 [0] No = Don't add Trunk Group ID as prefix (default).
 [1] Yes = Add Trunk Group ID as prefix to called number.
Notes:
 This option can be used to define various routing rules.
 To use this feature, you must configure the Trunk Group IDs (refer to
"Configuring the Trunk Group Table" on page 226).
Add Trunk ID as Prefix
[AddPortAsPrefix]
Determines whether the Trunk ID is added as a prefix to the called number
for Tel-to-IP calls.
 [0] No = Don't add Trunk ID as prefix (default).
 [1] Yes = Enable add Trunk ID as prefix.
If enabled, the Trunk ID (single digit in the range 1 to 8 ) is added as a
prefix to the called (destination) phone number.
This option can be used to define various routing rules.